How to press your transfer

Six steps, about thirty seconds a shirt. A heat press is best, but a household iron works for one-offs. Settings for both are below.

Temperature

150–160°C

Time

12–15 seconds

Pressure

Medium-firm

Peel

Warm, after 5 seconds

Step by step

1

Heat the press

Set it to 150–160°C. Let it come all the way up to temperature before the first press.

2

Flatten the shirt

Press the blank garment on its own for 5 seconds. This dries out damp fibres and flattens creases so the transfer sits flat.

3

Lay the transfer

Printed side down, film side up. Line it up by eye. A fingertip's width below the collar seam is a good full-front start.

4

Press

12–15 seconds at medium-firm pressure. The film should sit completely flat with no lifted corners.

5

Peel

Warm peel: wait 5 seconds, then pull the film in one smooth motion

6

Finish it

Re-press 5 seconds under parchment for a matte finish

Household iron? Highest cotton setting, no steam, no water in the tank. Press down hard and hold for 45–60 seconds. Don't slide it around like ironing. Let it cool a few seconds, then peel.

Settings by product

ProductHeatTimePeelDurability
DTF Transfer 150–160°C 12–15 seconds Warm peel: wait 5 seconds, then pull the film in one smooth motion Made to last through regular washing when pressed and cared for correctly
UV DTF Sticker No heat (do not press) Burnish 20 seconds by hand Peel the top transfer film slowly at a shallow angle Hand wash; avoid soaking, abrasive scrubbing and high heat
Glitter / Specialty DTF 150°C 15 seconds Cold peel: let it cool fully before removing the film Follow the finish-specific care instructions supplied with the order

Storing transfers: 6 months in a cool, dry place, out of direct sun. Keep them flat, printed sides not touching.

Washing

  • Wait 24 hours after pressing before the first wash.
  • Turn the garment inside out.
  • Cold water, gentle cycle, mild detergent. No bleach.
  • Hang dry if you can. Tumble dry low if you must.
  • Never iron directly on the print. Iron inside out.

Something went wrong?

The print is lifting at the edges

Not enough pressure or the press cooled down. Re-press for 10 seconds with firmer pressure and a fresh sheet of parchment on top.

The film is stuck and won't peel

You peeled cold on a warm-peel transfer, or the press was under temperature. Re-press for 5 seconds and peel while it's still warm.

The print cracked after washing

Almost always an under-press. Wash inside out, cold, and skip the tumble dryer. If it cracked on the first wash, send us a photo. That's a reprint on us.

There's a faint square around the design

That's press shine on the fabric, not the transfer. Cover with parchment and press the whole area for 3 seconds to even it out.

Colours look duller than my screen

Screens emit light while printed ink reflects it, so they cannot match exactly. Send us the file before ordering if a specific brand colour matters.

Ready to order?

Upload your design and see the price in seconds.

Start my order
Chat with us